Instructions for setting up oil injection control on thermoforming machine-Longsheng Industry

 Language

English 中文版 العربية



English 中文版 العربية

Return

WELCOME TO SHANTOU

Home page

Instructions for setting up oil injection control on thermoforming machine

Time: 2025-03-13 14:30:37.959

制杯机注油控制设置说明

Touchscreen settings：

设置运行时间为90秒，就是注油器的通电时间，模次设置可根据产品的生产频率为依据。

Set the operating time to 90 seconds, which is the electrification time for the lubricator. The cycle setting can be based on the production frequency of the product.

注油器设置

Lubricator settings

设置左边为注油时间：30或者40秒；右边为间隔时间：1分钟。（两个的单位不一样）

注意：触摸屏的通电时间必须大于或者等于注油器的间隔时间，否则会出现注油器还没开始注油就断电，造成缺油现象。

Set the left side for lubrication time: 30 or 40 seconds; the right side for interval time: 1 minute. (The units for the two are different.)

Note: The power-on time of the touchscreen must be greater than or equal to the lubricator's interval time, otherwise, the lubricator may shut off before it starts lubricating, causing an oil shortage.